| ... | ... | @@ -6,6 +6,6 @@ It should be connected to the female DC connector with a male DC 2.1x5.5mm plug. |
|
|
|
Do note that using this method of powering does not guarantee dust and water-resistant robustness.
|
|
|
|
|
|
|
|
## M12 Connector
|
|
|
|
To keep the robustness and weather-proof conditions intact we recommend using the M12 connector. This is also the required connector if synchronization with another sensor is required using the SYNC signal. Below you can find an image of the pin layout of the M12 connector as seen from the point-of-view of the sensor. As you can see pins 10 and 12 require the 12V input and pins 6 and 11 the ground. The other pins can be ignored if only power is required. The power required is about 24W so 12V, 2A.
|
|
|
|
To keep the robustness and weather-proof conditions intact we recommend using the M12 connector. This is also the connector to use if synchronization with another sensor is required using the SYNC signal or another method of triggering the measurements by hardware signals. Below you can find an image of the pin layout of the M12 connector as seen from the point-of-view of the sensor. As you can see pins 10 and 12 require the 12V input and pins 6 and 11 the ground. The other pins can be ignored if only power is required. The power required is about 24W so 12V, 2A.
|
|
|
|
|
|
|
|
 |
